Air Force Wife Decal - Air Force Mom Decal - Air Force Girlfriend - Military Decal - Military Spouse Yeti Cup Decal - Car Decal - Water Bottle Decal - Tumbler Sticker
This listing is for (1) custom vinyl decal. These are meant to be used on any hard, non-porous surfaces. Great for car windows, yetis, mugs, mirrors, glass, laptops, tablets, water bottles, tumblers, coolers, etc. (NOT to be used on walls) *NOTE - not dishwasher safe - Gentle Hand Wash Only*
If you are buying this for a specific item, please double check measurements before ordering - not responsible if decal is too small or large for a specific item, choose measurement accordingly.
*CHOOSE SIZE AND PERSON (WIFE, GIRLFRIEND, MOM, GRANDMA) FROM DROP DOWN MENUS
*PLEASE INCLUDE THE FOLLOWING INFO IN THE NOTES SECTION AT CHECKOUT (COPY AND PASTE BELOW INFO):
1. Main color
2. Color of Star and Person (wife, girlfriend, mom, etc)
Color choices can be seen in photos.
Application Instructions Included!
Decal is made of high quality UV Resistant Waterproof Vinyl with an outdoor life of 5+ years. We use several different industry-leading brands in order to bring you the most color choices. All vinyl will remove cleanly, but CANNOT be repositioned. It is very important to line up your art and tape the corners to step back and look at it BEFORE the final application to surface.
How the sizing works:
Sizes are measured TO THE LONGEST SIDE whether it be width or height.
Suggested sizes: ***sizes are measured by width***
YETI Colster - 3"
YETI Rambler 20 oz. - 3"
YETI Rambler 30 oz. - 3.5" or 4"
Your art arrives in three pieces – the bottom layer is a “carrier sheet”, then the vinyl, then an application tape on top. You MUST make sure your item is clean and dust free – any dirt or debris on the substrate (the item you apply the vinyl to) will keep your art from sticking properly. Then, eyeball AND/OR measure where you want your decal to be. Once you have lined up your decal and you know where you’d like to apply it, you need to remove the back (carrier sheet), and make sure the design has completely “stuck” to the application tape. Carefully position your art on the substrate, then use a hard, flat object to smooth it on, such as a credit card. Once you have rubbed the entire design, gently start to peel the transfer tape off, leaving the design on the substrate. If the design starts to come off with the tape, simply lay the tape back down and rub again until the design sticks.